How to store, protect and ship trading cards
Put any card worth keeping in a soft penny sleeve first, then in something stiff: a top loader for storage and posting, a semi-rigid holder if it is going to a grader, or a one-touch magnetic case for display. Keep cards dry, out of sunlight and in side-loading binder pages, and post a single card as sleeve, top loader, sealed bag, then cardboard.
Last checked November 12, 2026 against PSA's shipping guide and eBay's Standard Envelope help pagePublished November 12, 2026By the TCGenius team
On this page
The layers, from soft to stiff
Every method is the same idea: something soft against the card so it can't scratch, then something stiff so it can't bend.
| Holder | What it is | Use it for |
|---|---|---|
| Penny sleeve | A thin, soft, clear sleeve | The first layer on every card you care about. On its own it stops scratches, not bends. |
| Top loader | A stiff plastic sleeve, open at the top | Storing and posting single cards. Always sleeve the card first: sliding a bare card in scratches the surface. |
| Semi-rigid holder | A thinner, slightly flexible holder that is wider than the card (Card Saver 1 is the best-known) | Sending cards to a grader. The card comes out without being pushed past a tight edge. |
| One-touch magnetic holder | Two hard clear halves that close with a magnet | Displaying a favourite card. Sized by thickness, in points. |
| Team bag | A resealable bag that fits a top loader | Closing the open top of a top loader so the card can't slide out, and keeping water off in the post. |
What graders ask for. PSA's shipping guide says to put each card in a clear penny sleeve and then a semi-rigid holder, and not to use top loaders, tape, pull tabs or sticky notes. For standard trading cards it asks for semi-rigid holders of 3 5/16 by 4 7/8 inches. Other graders publish their own packing rules, so read the one you are sending to.
One-touch sizes: what the points mean
One-touch holders are sold by the thickness of card they fit, measured in points. One point is a thousandth of an inch.
- 35pt is the size for a standard trading card: an ordinary Pokémon, Yu-Gi-Oh!, One Piece, Magic or Lorcana card.
- 55pt, 75pt, 100pt, 130pt and 180pt are for thicker cards, such as cards with a piece of material set into them or extra-thick promos.
If the two halves don't close flat without pressure, the holder is too thin for the card: go up a size and never force it. A card that rattles around is in a holder that is too thick. Standard-size one-touches fit a card of about 63 by 88 mm, so a smaller Yu-Gi-Oh! card will have a little room around it.
Sleeve sizes by game
Cards come in two sizes, and sleeves are sold to match.
| Card size | About | Games | Sleeves are sold as |
|---|---|---|---|
| Standard | 63 × 88 mm (2.5 × 3.5 inches) | Pokémon, Magic: The Gathering, One Piece, Disney Lorcana | Standard size |
| Small | 59 × 86 mm | Yu-Gi-Oh! | Japanese size, or small size |
A Yu-Gi-Oh! card in a standard sleeve slides around and can catch a corner; a standard card will not fit a small sleeve at all. Penny sleeves and top loaders are made for the standard size, and a Yu-Gi-Oh! card fits them with room to spare.
Players often double-sleeve a deck: a tight inner sleeve put on from the top, then a normal sleeve from the bottom, so nothing can reach the card. That is for play. For storage, one penny sleeve and a stiff holder is enough.
Binders: side-loading pages, and why rings dent cards
A binder is the nicest way to look at a set, and the wrong one damages it.
- Use side-loading pages. The pocket opens toward the spine, so cards can't slide out of the top when the binder is carried or tipped.
- Be careful with ring binders. When a ring binder is overfilled or closed carelessly, the pages nearest the spine fold over the rings and the rings press a dent into the column of cards beside them. Binders with fixed, stitched-in pages have no rings to do it. If you use rings, D-shaped rings hold the pages flatter than round ones, and the binder should never be packed full.
- One card per pocket, sleeved first for anything you care about.
- Store binders upright, like books, not in a stack. The weight of a stack presses on the cards at the bottom.
Damp, heat and light
Cards are paper, and foil cards are paper with a layer of foil glued on. The two layers take up moisture differently, which is why foil cards curl.
- Keep them dry and steady. A cupboard in a lived-in room is better than a loft, a garage, a cellar or a spot next to a radiator or a window. Big swings in humidity do more harm than a steady room.
- Keep them out of direct sunlight. Sunlight fades inks over time, even through a plastic case. A case sold as UV-resistant slows this down; it does not make a windowsill safe.
- Keep sealed boxes off the floor and away from outside walls, where damp collects.
- Handle by the edges, with clean dry hands. Fingerprints on a foil surface can show up under a grader's light.
How to ship a single card
- Put the card in a penny sleeve.
- Slide the sleeved card into a top loader.
- Seal the top loader in a team bag, or tape across the opening with a strip of low-tack painter's tape folded over at one end so the buyer can peel it. Never let tape touch the card or the sleeve.
- Sandwich the top loader between two pieces of cardboard a little bigger than it, and tape the cardboard together so the card can't slide out.
- Put it in an envelope for a low-value card, or a padded mailer or small box with tracking for anything valuable.
- Photograph the packed card before you seal it, in case of a claim.
eBay Standard Envelope. Sellers in the US can post cheap cards with tracking through eBay's own envelope service. As read on eBay's help page on November 12, 2026: each item must have sold for $20 or less, the envelope can weigh up to 3 ounces and must be under a quarter of an inch thick and not rigid, it can hold no more than two cards in top loaders, and graded cards are not allowed. Shipping protection covers $20 on a single order and up to $50 on a combined one. Anything worth more should go in a tracked package.
Do it with TCGenius
Questions people ask
What is the best way to protect trading cards?
A penny sleeve first, then a stiff holder: a top loader for storage and posting, a semi-rigid holder for grading submissions, or a one-touch magnetic case for display. Keep them dry and out of sunlight.
What does PSA want cards sent in?
PSA's shipping guide asks for each card in a clear penny sleeve inside a semi-rigid holder, and says not to use top loaders, tape, pull tabs or sticky notes.
What size one-touch do I need for a Pokémon card?
35pt fits a standard trading card. Thicker cards need 55pt, 75pt, 100pt, 130pt or 180pt. If the holder doesn't close flat without pressure, go up a size.
Do Yu-Gi-Oh! cards need different sleeves?
Yes. Yu-Gi-Oh! cards are about 59 by 86 mm and use Japanese-size (small) sleeves. Pokémon, Magic, One Piece and Lorcana cards are about 63 by 88 mm and use standard-size sleeves.
Do ring binders damage cards?
They can. In an overfilled ring binder the pages by the spine fold over the rings, which press dents into the nearest cards. Side-loading pages in a binder with fixed pages avoid it.
How do I ship a single card safely?
Penny sleeve, top loader, team bag, then two pieces of cardboard taped together, in an envelope for a cheap card or a tracked padded mailer for a valuable one.
Can I use eBay Standard Envelope for any card?
No. As read on eBay's help page on November 12, 2026, each item must have sold for $20 or less, the envelope must weigh 3 ounces or less and be under a quarter inch thick, and graded cards are not allowed.
Sources
- PSA Shipping Guide: how to package a submission, psacard.com (read November 12, 2026)
- eBay Standard Envelope help page, ebay.com (read November 12, 2026)
Rules and dates change. When a card or an official document says something different from this page, the official wording wins; tell us and we will fix the page.
Keep reading
TCGenius is an independent fan site. We are not affiliated with or endorsed by The Pokémon Company, Nintendo, Konami, Bandai, Wizards of the Coast, Hasbro, Riot Games, Disney or Ravensburger. Game names and card images belong to their owners.